Mitsubishi Electric M700V Series Programming Manual page 502

13. Program Support Functions
Format Function
G05 P1 High-speed machining
(Note 1) mode
P2
(Note 1)
P10000 High-speed
(Note 2) high-accuracy control II
G05.1 High-speed
(Note 2) high-accuracy control I
G06.2 NURBS interpolation
G07 Hypothetical axis
interpolation
(Not implemented)
G07.1 Cylindrical Interpolation P942
G107
G08 P0 High-accuracy control
(Note 2)
P1
G09 Exact Stop Check
G10/G11.1 Parameter input by
program
G10 Compensation data
input by program
G12/G13 Circular cutting
G12.1/G13.1 Polar coordinate
interpolation
G15/G16 Polar coordinate
command
(Note 1) It is valid when the parameter "#1267 ext03/bit0" is OFF. If it is commanded when the
(Note 2) It is valid when the parameter "#1267 ext03/bit0" is ON. If it is commanded when the
The function indicated at
the left is commanded in
the modal of this function
Max. feedrate is
16.8m/min when 1mm
segment G1 block is
commanded with 5 axes
simultaneously
Max. feedrate is 100m/min
when 1mm segment G1
block is commanded with 5
axes simultaneously
Max. feedrate is 100m/min
when 1mm segment G1
block is commanded with 5
axes simultaneously
Max. feedrate is
16.8m/min when 1mm
segment G1 block is
commanded with 5 axes
simultaneously
P942
P942
Tool center point control is
performed in the cutting
mode.
Tool center point control is
performed in the
high-accuracy control
mode.
Deceleration check is
performed at the block
end.
P942
P942
P942
P942
P942
parameter is ON, the program error (P34) will occur.
parameter is OFF, the program error (P34) will occur.
13.24 Tool Center Point Control; G43.4/G43.5
This function is
commanded in the modal
indicated at the left
Max. feedrate is 16.8m/min
when 1mm segment G1
block is commanded with 5
axes simultaneously
Max. feedrate is 100m/min
when 1mm segment G1
block is commanded with 5
axes simultaneously
P941
Max. feedrate is 16.8m/min
when 1mm segment G1
block is commanded with 5
axes simultaneously
P*** NURBS general error P941
-
P941
Tool center point control is
performed in the cutting
mode.
Tool center point control is
performed in the
high-accuracy control
mode.
-
-
-
-
P941
P941
490
This function is
commanded in the same
block
P33
P33
P33
P33
P941
P941
P33
P33
Deceleration check is
performed at the block
end.
P941
P941
Tool center point control is
ignored as the circular
cutting takes precedence
over the tool center point
control function.
P941
P941