Mitsubishi Electric M700V Series Programming Manual page 508

13. Program Support Functions
(25) Actual feed rate display
The final combined feed rate is displayed here.
(26) Manual interruption
When the manual interruption is executed during the feed hold or single block stop, the
movement will be the one to be observed when the manual ABS is OFF when rebooting
regardless of whether an absolute/incremental value command is selected.
(27) Machine lock
The each Machine Lock becomes valid to the motor axis.
(28) Remaining distance counter
Remaining distance at the tool center point on the programming coordinate system is
displayed.
(29) Interlock
Interlock is applied for the motor axis.
(30) Cutting feed / Rapid traverse override
Override is applied to the feedrate at the tool center point. When the federate is clamped, the
override is applied to the clamp speed.
(31) Manual reference position return
If the manual reference position return is performed during the tool center point control, the tool
moves off the programmed track after that.
(32) Dry run
Dry run is applied to the speed at the tool center point.
(33) NC reset
Immediately decelerates to stop when the NC reset is executed during the tool center point
control. The tool center point control will be canceled even if NC reset 1 and the modal
retention.
(34) Emergency stop
Immediately stops if the emergency stop is applied during the tool center point control.
(35) Stored stroke limit
Stored stroke limit will be valid at the motor axis for all IB, IIB and IC.
(36) MDI interruption
When the MDI interruption is performed during the tool center point control, an operation error
(O170) occurs.
13.24 Tool Center Point Control; G43.4/G43.5
496