Configuring IPX RIP parameters
Step
1.
Enter system view.
2.
Specify an IPX RIP update
interval.
3.
Configure an aging interval
for IPX RIP routing entries.
4.
Enter interface view.
5.
Configure
length of IPX RIP updates.
Configuring IPX SAP
With IPX enabled on an interface, the system automatically uses SAP to maintain and advertise dynamic
service information. You can also configure the SAP related parameters or service information based on
actual network requirements.
Configuration prerequisite
You need configure IPX basic functions before this task.
Enabling IPX SAP
Step
1.
Enter system view.
2.
Enter interface view.
3.
Enable IPX SAP.
Command
system-view
ipx rip timer update
seconds
ipx rip multiplier multiplier
interface interface-type
interface-number
the
maximum
ipx rip mtu bytes
Command
system-view
interface interface-type
interface-number
undo ipx sap disable
Remarks
—
Optional.
The default is 60 seconds.
The IPX RIP update interval must be identical
on all routers in the network to keep
consistency of routing tables.
If a route entry is not updated within the
aging interval, it is removed from the routing
table and the associated dynamic service
information entry is also removed.
Optional.
The default is 3 times the update interval.
—
Optional.
The default is 432 bytes.
Remarks
—
—
Optional.
By default, IPX SAP is enabled after IPX is enabled on
the interface.
5