Humidity Analyzer - Setting Display Item - YOKOGAWA ZR22G User Manual

(3) To set the minimum humidity at 4 mA, choose the Min. humidity conc. To set the maximum
humidity at 20 mA, choose the Max. humidity conc.
(4) To set 50% H
(5) Set "mA-output2" in the same manner as in the appropriate steps above.
NOTE
Analog output range settings should be limited. For more details, consult Section 8.1, "Current
Output setting," later in this manual.
7.9 Setting Display Item
7.9.1 Oxygen Analyzer - Setting Display Item
This section briefly describes the display item settings shown in Figure 7.13, "Basic Panel
Display."
Primary value
Secondary value
Tertiary value
Figure 7.13
(1) Press the [Setup] key in the Basic panel display to display the Execution/Setup display.
Then select "Maintenance" in the Execution/Setup display.
(2) Select the "Display setup" from the Maintenance panel display (Figure 7.14).
The Display setup display (Figure 7.15) then appears.
(3) In the above Display setup display, select the "Display item". The Display item display
(Figure 7.16) then appears. From this display, select the "Primary value" and press the
[Enter] key to display the "Display item" selection display (Figure 7.17).
(4) Select the Secondary and Tertiary values in the same manner as in the steps above.
(5) Consult Table 7.1, Display Items, enabling the selection of display items in individual display
areas.
O, type in 050 and press the [Enter] key.
2
Tag:
21.0
17.43mA -Output1
17.43mA -Output2
Basic Panel Display
<7. Startup>
%O
2
F7.11E.ai
IM 11M12A01-02E
7-6
16th Edition : Mar. 19, 2020-00