Checking Calibration Contact Output; Checking Input Contacts - YOKOGAWA ZR22G User Manual

Maintenance
Display setup
Calibration setup

Blow back setup

mA-output loop check

Contact check

Figure 7.19 Maintenance Panel Display
Display item
Primary value:
Humidity
Secondary value:

mA-output1
Tertiary value:

mA-output2
Tag name:

Figure 7.21 Display Item Display
Table 7.2 Display Items
Item Primary value
Oxygen
concentration
Humidity
Mixing ratio
Relative humidity
Dew point
Output 1 item
Output 2 item
Current output 1
Current output 2
*1: If an analog output damping constant is set, the oxygen concentration display then includes these settings.
NOTE
For the relative humidity and dew-point calculations, appropriate operation parameters should
be entered. For details on the parameters, consult Section 8.6.3, "Setting Measurement Gas
Temperature and Pressure," later in this manual.
Enter
F7-12.ai
Enter
F7-14.ai
Secondary and
tertiary values
○ ○
○ ○
○ ○
○
○
○ ○
○ ○
○
○
<7. Startup>
Display setup
Display item
Trend graph

Auto return time:

Language: English

Figure 7.20 Display Setup
Display item
Primary value:
Oxygen
Oxygen
Humidity
Secondary value:

Mixing
mA-output1
Item of output1 damping
Item of output2 damping
Tertiary value:

mA-output2
Tag name:

Figure 7.22 Display Item Selection
Oxygen concentration during measurement
Humidity (%H O) in the exhaust gas
2
Mixing ratio during measurement
Relative humidity calculated from the measured value
Dew point calculated from the measured value
Oxygen concentration with the equipment set for oxygen
analyzer (See *1 below.)
Oxygen concentration with the equipment set for oxygen
analyzer (See *1 below.)
Current value output from analog output 1
Current value output from analog output
IM 11M12A01-02E
7-9
0min
Enter
F7-13.ai
Enter
F7-15.ai
Display
16th Edition : Mar. 19, 2020-00