Recovery Mode; Figure 104 - Recovery Mode Warning Page - Motorola PTP 600 Series User Manual

9 Recovery Mode

9 Recovery Mode
The Motorola PTP 600 point-to-point wireless Ethernet bridges have a special mode of
operation that allows the user to recover a unit from configuration errors or software image
corruption.
Recovery mode is entered by depressing the Recovery Switch located on the underside of
the PIDU Plus while applying mains power, as shown in Section 3.3.2 "PIDU Plus – PTP 600
Series Bridge" The Recovery Switch should be held in the depressed state for between 10
and 20 seconds after the application of mains power. The Ethernet LED will flash with 10
double flashes at power up (following the release of the Recovery switch).
When in recovery mode the user will be able to access the unit via the Ethernet interface. The
Ethernet interface will have its IP address set to 169.254.1.1 (or 10.10.10.10 see section
7.7.10 "Powering Up"). On connection to a unit in recovery mode the following screen is
displayed (Figure 104):

Figure 104 - Recovery Mode Warning Page

199