Telecoms Interface; Figure 68 - Telecoms Configuration Interface - Motorola PTP 600 Series User Manual

8 Web Page Reference
8.3.4.3

Telecoms Interface

If the telecoms interface is configured to either T1 or E1 then Step 1 of the installation wizard
contains additional configuration fields.

Figure 68 - Telecoms Configuration Interface

The additional E1 or T1 fields are:
Telecoms Channel Selection: This controls the selection of the telecoms interface standard
supported options or T1 and E1.
Channel A Line Code: The line code setting of the telecoms interface. This must match the
setting of the device connected to this interface.
Channel B Line Code: The line code setting of the telecoms interface. This must match the
setting of the device connected to this interface.
Cable Length: This field is applicable to the T1 operating mode only. It configures the T1
transceiver to output a signal suitable for driving a cable of the specified length. This should
be set to reflect the length of cable between the wireless unit and the connected equipment.
155