Motorola PTP 600 Series User Manual page 136

Point-to-point wireless solutions
Hide thumbs Also See for PTP 600 Series:
Table of Contents

Advertisement

8 Web Page Reference
Gateway IP Address: The IP address of a computer / router on the current network that acts
as a gateway.
VLAN High Priority Traffic Threshold: All packets with an 802.1P priority tag greater than
or equal to the indicated value will be treated as a high priority packet for transmission over
the wireless link.
Use VLAN For Management Interfaces: This controls use of VLAN tags at the management
interfaces (WWW/SNMP/SMTP/SNTP). See Section 8.3.1.3 "LAN Configuration Page – Use
VLAN For Management Interfaces".
Ethernet Auto Negotiation This enables the Ethernet configuration to be forced rather than
auto negotiated.
CAUTION: The configuration should only be forced if you are having problems with auto
negotiation. You must ensure that you configure both this unit and the Ethernet port to which
it is connected identically. If you force a fixed Ethernet Configuration on the 600 Series bridge
then you MUST also force the same fixed configuration on the equipment to which it is
connected. If you fail to force the configuration of the connected equipment, its automatic
configuration mechanisms will normally cause a duplex mismatch, and you will receive greatly
reduced throughput!
When Ethernet Auto Negotiation is Disabled the format of the LAN configuration page will
change see Section 8.3.1.4 "LAN Configuration Page – Manual Ethernet Configuration".
Auto Neg Advertisement: This controls the rates that the auto negotiation mechanism will
advertise as available.
CAUTION: Over the air throughput will be capped to the rate of the Ethernet interface at the
receiving end of the link.
Ethernet Auto Mdix: This enables/disables the Auto Medium Dependent Interface
(MDI)/Medium Dependent Interface Crossover (MDIX) capability. Default is "Enabled".
Drop Ethernet Link On Wireless Link Down: When this option is enabled the Ethernet link
is momentarily dropped when the wireless link goes down. This feature is used to indicate to
the connected network equipment that this Ethernet link is no longer available, thus causing
STP (Spanning Tree Protocol) to re-route packets through an alternative link.
134

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents