Motorola PTP 600 Series User Manual page 124

8 Web Page Reference
Install Status: A non-OK value indicates that signaling was received with the wrong MAC
address. Note that it is very unusual to detect this, because units with wrongly configured
Target MAC Address will normally fail to establish a wireless link. However, rare
circumstances may establish a partial wireless link and detect this situation. NB: A non-OK
value on start-up, or a change of value during operation, may generate an SNMP trap and/or
SMTP email alert.
Install Arm State: This alarm warns when a wireless unit is in installation mode. After
installation the wireless unit should be disarmed. This will increase the wireless link's data-
carrying capacity and stop the installation tone generator. The wireless link is disarmed from
the 'Installation Wizard' see Section 8.3.4.6 "Disarm". A change of state may generate an
SNMP trap and/or SMTP email alert.
Unit Out Of Calibration: The unit is out of calibration and must be returned to the factory
using the RMA process for re-calibration.
Encryption Enable Mismatch (see section 17 "AES Encryption Upgrade"): Encryption has
been enabled on one end of the wireless link but not the other.
Incompatible Region Codes: The PTP 600 Series Bridge uses region codes to comply with
local regulatory requirements governing the transmission of wireless signals in the 5.9 GHz,
5.8 GHz, 5.4 GHz, 4.5 GHz and 2.5 GHz bands. Region codes can only be changed by
obtaining a new PTP600. Note that a change of state may generate an SNMP trap and/or
SMTP email alert.
Series license key: If this alarm is encountered the appropriate license keys from the country
of operation should be obtained from your distributor. Applying license keys containing the
same region codes to both ends of the link will remove the alarm.
No Wireless Channel Available: Spectrum Management was unable to locate a suitable
wireless channel to operate on. Note that a change of state may generate an SNMP trap
and/or SMTP email alert.
Wireless Link Disable Warning: This warning is displayed if the Wireless link has been
administratively disabled via the SNMP Interface (see Section 8.3.11 "Remote Management
Page"). The Wireless Interface MIB-II ifAdminStatus attribute has been set to DOWN. To
enable the Ethernet interface, set the ifAdminStatus attribute to UP. Note that a change of
state may generate an SNMP trap and/or SMTP email alert.
122