Remote Leds And Recovery Switch; Cables And Connectors; Figure 11 - Remote Led And Recovery Switch Wiring - Motorola PTP 600 Series User Manual

3.3.4

Remote LEDs and Recovery Switch

The PTP 600 Series Bridge PIDU Plus provides a facility to connect remote LEDs and
Recovery switch allowing the PIDU Plus to be mounted inside an enclosure. At the left hand
end of the PIDU Plus under the ODU connection cover can be found a PCB header and three
jumpers. Jumpers J906 and J907 should be removed and connection to the remote LEDs and
Recovery switch made to J908 as shown in Figure 11.

Figure 11 - Remote LED and Recovery Switch Wiring

3.3.5

Cables and connectors

The cable used to connect the PTP 600 Series Bridge PIDU Plus to the ODU can be any
standard CAT5e type provided that it is suitable for outdoor deployment. Motorola
recommends that cables to the specification below be used:
Cable:
Connector Type:
Gland:
CAUTION: Failure to use the recommended (or equivalent) standard of cable may invalidate
the system's safety certification.
The cable used to connect the PTP 600 Series Bridge PIDU Plus to the users Network
Equipment can be any standard CAT5e Cable.
Superior Essex BBDGE CAT 5e
Tyco, 5-569278
Motorola WB1811
43
3 Getting Started