Figure 2 - Mod Record Label - Motorola PTP 600 Series User Manual

Each end of the link consists of:
x
An integrated (or connectorized -see section 13) outdoor transceiver unit containing all
the radio and networking electronics hereafter referred to as the Outdoor Unit (ODU).
x
An indoor connection box containing a mains power supply, status indicators and network
connection port. Hereafter referred to as the Power Indoor Unit Plus (PIDU Plus).
A pair of units is normally supplied pre-configured as a link.
The network connection to a PTP 600 Series Bridge is made via a 1000BaseT Ethernet
connection. Power is provided to the ODU over the 1000BaseT Ethernet connection using a
patented non-standard powering technique.
Previous releases of the PTP 600 Series Bridge platform used different powering and
connection arrangements. Users of equipment prior to "Mod Record 1" should refer to the
User Guide shipped with the original equipment. The "Mod Record" label can be found on the
back of the ODU as shown in Figure 2.
Alternatively, the network connection to a PTP 600 Series Bridge can be made using a
1000BaseSX Fiber Optic cable connected directly to the ODU. In this case power is still
provided over the 1000BaseT Ethernet connection. In the case of Fiber Optic cable failure the
PTP 600 Series Bridge will automatically fall back to the copper Ethernet connection
(provided the cable length <=100m [330 ft]). "PTP 600 Series Optical Interface Upgrade Kits"
can be obtained from your distributor, reseller or system integrator.
Power is fed into the PTP 600 Series Bridge PIDU Plus from the mains via a standard "figure
of eight" mains plug. Connection between the ODU and PIDU Plus is made using standard
CAT5e outdoor UV resistant cable. Connection between the PIDU Plus and the Network
Equipment is made using standard CAT5e cable.

Figure 2 - Mod Record Label

37
3 Getting Started