Table 44 - Common Burst Durations - Motorola PTP 600 Series User Manual

Bandwidths in Network: It is very likely that there will be several different channel
bandwidths in a given network. Table 44 gives a list of bandwidth combinations that permit
synchronization without gross loss of efficiency. Depending on the channel bandwidth size,
only subsets of Table 44 will be shown in the configuration wizard screen.
Collocated Masters: The network needs to be configured differently depending on whether
all masters for which interference can potentially occur are collocated or whether interference
needs to be considered for masters which are not collocated. Answer "Yes" to this question if
master to master interference only occurs between collocated masters, otherwise answer
"No". If "No" is selected, the maximum distance between masters which can potentially
interfere is required. This is the subject of the next bullet.
Master to Master Range: This is only displayed (see Figure 138.) if the answer to the above
question was "No". In this case, the longest distance over which two masters can interfere
must be entered here. Maximum range is 200 km (120 miles).
Slave Interfere: Select "No" if there is no potential of a slave interfering with another slave.
Select "Yes" if there is potential for one slave to interfere with another slave. If the option
"Yes" is selected, then the maximum distance between slaves which can potentially interfere
is required. This is the subject of the next bullet.
Slave to Slave Range: This is only displayed (see Figure 138.) if the answer to the above
question was "Yes". In this case, the longest distance over which two slaves can interfere
must be entered here. Maximum range is 200 km (120 miles).
14 TDD Synchronization Configuration and Installation

Table 44 - Common Burst Durations

Bandwidth
Combination
(MHz)
30
30/5
30/10
5/10/30
15/30
15
10/15
5/10
10
5
263
Guide