Caring For The Uav - Intel Falcon 8+ User Manual

Table 6-3. Firmware Update for the Cockpit Control application
5. Tap on the info button in the lower left corner of the touchscreen tablet.
6. In the next screen tap on
All update files found on the USB stick will be displayed in the center of the screen.
7. Tap on the update file that should be installed.
A dialog will pop up.
8. Tap on
The Cockpit Control application will be closed.
9. Confirm the next dialog
A progress bar will be shown.
When the update is finished, there will be a respective message.
10. Tap on
You will be asked to restart the system.
11. Tap on
12. If necessary, adjust the time and date.
13. Tap on
14. Confirm the
15. Tap on the info button in the lower left corner.
16. Check the installed Cockpit Control version in the about dialog.
The newly installed version should be shown.
6.1.2

Caring for the UAV

Please consider the next points in order to keep the UAV in good condition; so it will be
ready for use every time.
• Strict compliance with the Safety Guidelines and Safety Precautions (UAV and
safety check, pre-flight check and post-flight check, see
Safety
• We recommend an annual check from the manufacturer, during which the system is
fully tested. For details please contact your dealer.
Cleaning
If necessary you should clean the UAV after the mission, or before storing.
Caution: If you use water: No moisture/water should reach the motors or electrical
contacts.
• Use a soft lint-free cloth (e.g. microfiber) for cleaning the outer parts (motor rails,
canopy, propellers) carefully.
• If indicated you can moisten the cloth with warm water, to which you can add a
mild dishwashing detergent if necessary.
• As well possible for (dry) cleaning is the using of a small, soft paintbrush.
• For cleaning (especially the motors) and drying you can also use canned
compressed air, which is available at many computer stores.
Caution: When you use compressed air for cleaning the UAV, it is mandatory to hold/fix
the propellers during the blowing out procedure. Otherwise, voltages can be
generated, which can damage the whole system electronics.
114
Updates
to confirm the dialog.
YES
Cockpit Control Setup Wizard
to confirm this message.
Finish
to confirm. After the restart, the dialog for time and date settings is shown.
Yes
.
APPLY SETTINGS
Preflight Checklist
Check) ensures that defects can be found before a flight.
User Manual
in the lower left corner.
with tapping on
.
.
Install
chapter 1.2 UAS and
®
TM
Intel Falcon F8+