Brake Release Switch
NOTE: If the machine's batteries are completely depleted of elec-
trical charge the brakes cannot be released electrically.
The brakes must be released mechanically, see "Mechani-
cal Brake Release" on page 4-20.
DO NOT MANUALLY DISENGAGE THE BRAKES UNLESS THE MACHINE IS SET-
TING ON A LEVEL SURFACE OR THE MACHINE IS FULLY RESTRAINED.
1. The brake release switch (1) is located on the lower
rear panel (2) on the machine.
2. The machine must be powered ON to GROUND CON-
TROL MODE at the Platform/Off/Ground Selector
Switch on the Ground Control Station (3) to operate
the brake release switch.
3121221
SECTION 3 - MACHINE CONTROLS AND INDICATORS
Figure 3-6. Location of Brake Release Switch
– JLG Lift –
2
1
(Rear of Machine)
3
3-7