Communication - JLG 1230ES Operation And Safety Manual

SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
4-4 Battery Supply
DTC FAULT MESSAGE
444 LSS BATTERY VOLTAGE TOO LOW
446 LOGIC SUPPLY VOLTAGE OUT OF RANGE The System Module logic supply voltage
4421
4422

6-6 Communication

DTC FAULT MESSAGE
661 CANBUS FAILURE - POWER MODULE
662 CANBUS FAILURE - PLATFORM MODULE In platform mode, the control system failed
663 CANBUS FAILURE - LOAD SENSING SYS-
TEM MODULE
664 CANBUS FAILURE - ACCESSORY MOD-
ULE
6635 CANBUS FAILURE - CHASSIS TILT SEN-
SOR
6-22
DESCRIPTION
A problem has been detected with the load
sense system.
was measured to be out of normal operating
range.
DESCRIPTION
The control system failed to receive mes-
sages from the power module.
to receive messages from the platform
board.
With load sensing system enabled, the con-
trol system failed to receive messages from
the load sensing system module.
An accessory module has stopped commu-
nication.
Machine control system lost communica-
tion with the machines' tilt sensor.
– JLG Lift –
CHECK
• Recharge batteries or check for damaged batteries.
Refer problem to a qualified JLG mechanic.
• Check for severely discharged battery, loose cables or for damaged bat-
tery; otherwise;
• Refer problem to a qualified JLG mechanic.
CHECK
Refer problem to a qualified JLG mechanic.
Refer problem to a qualified JLG mechanic.
Refer problem to a qualified JLG mechanic.
• See accessory module documentation for troubleshooting.
Refer problem to a qualified JLG mechanic.
• Refer problem to a qualified JLG mechanic.
3121221