AudioCodes Mediant 500 E-SBC User Manual page 717

User's Manual
Parameter
Web: Use Default Proxy
EMS: Proxy Used
CLI: enable-proxy
[IsProxyUsed]
Web/EMS: Proxy Name
CLI: proxy-name
[ProxyName]
Web: Use Proxy IP as Host
CLI: use-proxy-ip-as-host
[UseProxyIPasHost]
Web: Redundancy Mode
EMS: Proxy Redundancy Mode
CLI: redundancy-mode
[ProxyRedundancyMode]
Web: Proxy IP List Refresh Time
EMS: IP List Refresh Time
Version 6.8
Enables the use of a SIP proxy server.

[0] No = (Default) Proxy isn't used and instead, the internal
routing table is used.

[1] Yes = Proxy server is used.
Notes:

This parameter must be used only for backward
compatibility. If not required for backward compatibility,
make sure that this parameter is disabled, and use the
Proxy Set table for configuring all your Proxy Sets (except
for Proxy Set ID 0).

This parameter is applicable only to the Gateway
application.
Defines the Home Proxy domain name. If specified, this name
is used as the Request-URI in REGISTER, INVITE and other
SIP messages, and as the host part of the To header in INVITE
messages. If not specified, the Proxy IP address is used
instead.
The valid value is a string of up to 49 characters.
Note: This parameter functions together with the
UseProxyIPasHost parameter.
Enables the use of the proxy server's IP address (in dotted-
decimal notation) as the host name in SIP From and To
headers in REGISTER requests.

[0] Disable (default)

[1] Enable
If this parameter is disabled and the device registers to an IP
Group (i.e., proxy server), it uses the string configured by the
ProxyName parameter as the host name in the REGISTER's
Request-URI and uses the string configured by the IP Group
table parameter, SIPGroupName as the host name in the To
and From headers. If the IP Group is configured with a Proxy
Set that has multiple IP addresses, all the REGISTER
messages sent to these proxies are sent with the same host
name.
Note: If this parameter is disabled and the ProxyName
parameter is not configured, the proxy's IP address is used as
the host name in the REGISTER Request-URI.
Determines whether the device switches back to the primary
Proxy after using a redundant Proxy.

[0] Parking = (Default) The device continues working with a
redundant (now active) Proxy until the next failure, after
which it works with the next redundant Proxy.

[1] Homing = The device always tries to work with the
primary Proxy server (i.e., switches back to the primary
Proxy whenever it's available).
Note: To use this Proxy Redundancy mechanism, you need to
enable the keep-alive with Proxy option, by setting the
parameter EnableProxyKeepAlive to 1 or 2.
Defines the time interval (in seconds) between each Proxy IP
list refresh.
717
53. Configuration Parameters Reference
Description
Mediant 500 E-SBC