Installing Software License Key Using Cli - AudioCodes Mediant 500 E-SBC User Manual

User's Manual
3. Depending on whether you are loading a Software License Key file with a single
Software License Key (i.e., one "S/N") or with multiple Software License Keys (i.e.,
more than one "S/N"), do one of the following:
•
Loading a File with a Single Software License Key:
a.
b.
c.
•
Loading a File with Multiple Software License Keys:
a.
b.
If the Software License Key is valid, it is burned to the device's flash memory and
displayed in the 'Current Key' field.
4. Verify that the Software License Key was successfully installed, by doing one of the
following:
•
In the Software Upgrade Key Status page, check that the listed features and
capabilities activated by the installed Software License Key match those that
were ordered.
•
Access the Syslog server and ensure that the following message appears in the
Syslog server:
"S/N___ Key Was Updated. The Board Needs to be Reloaded with ini file\n"
5. Reset the device; the new capabilities and resources enabled by the Software License
Key are active.
Note:
loaded (i.e., the "SN_" line is blank), do the following preliminary troubleshooting
procedures:

38.2.2.2 Installing Software License Key using CLI

To install the Software License Key using CLI, use the following commands:

To install the Software License Key:
(config-system)# feature-key <"string enclosed in double
quotation marks">

To view the Software License Key:
show system feature-key
Version 6.8
Open the Software License Key file using a text-based program such as
Notepad.
Copy-and-paste the string from the file to the 'Add a Software Upgrade Key'
field.
Click the Add Key button.
In the 'Load Upgrade Key file ...' field, click the Browse button and navigate
to the folder in which the Software License Key file is located on your
computer.
Click Load File; the new key is installed on the device.
If the Syslog server indicates that the Software License Key was unsuccessfully
1. Open the Software License Key file and check that the "S/N" line
appears. If it does not appear, contact AudioCodes.
2. Verify that you have loaded the correct file. Open the file and ensure that
the first line displays "[LicenseKeys]".
3. Verify that the content of the file has not been altered.
561
38. Software Upgrade
Mediant 500 E-SBC