Media; Configuring Voice Settings; Configuring Voice Gain (Volume) Control; Silence Suppression (Compression) - AudioCodes Mediant 500 E-SBC User Manual

Enterprise session border controller digital voip media gateway
Hide thumbs Also See for Mediant 500 E-SBC:
Table of Contents

Advertisement

User's Manual
14

Media

This section describes the media-related configuration.
14.1

Configuring Voice Settings

The Voice Settings page configures various voice parameters such as voice volume,
silence suppression, and DTMF transport type. For a detailed description of these
parameters, see ''Configuration Parameters Reference'' on page 673.
To configure the voice parameters:
1.
Open the Voice Settings page (Configuration tab > VoIP menu > Media > Voice
Settings).
2.
Configure the Voice parameters as required.
3.
Click Submit.
4.
To save the changes to flash memory, see ''Saving Configuration'' on page 530.

14.1.1 Configuring Voice Gain (Volume) Control

The device allows you to configure the level of the received (input gain) Tel-to-IP signal
and the level of the transmitted (output gain) IP-to-Tel signal. The gain can be set between
-32 and 31 decibels (dB).
The following procedure describes how to configure gain control using the Web interface:
To configure gain control using the Web interface:
1.
Open the Voice Settings page (Configuration tab > VoIP menu > Media > Voice
Settings).
Figure 14-1: Voice Volume Parameters in Voice Settings Page
2.
Configure the following parameters:
'Voice Volume' (VoiceVolume) - Defines the voice gain control (in decibels) for IP-
to-Tel
'Input Gain' (InputGain) - Defines the PCM input gain control (in decibels) for Tel-
to-IP
3.
Click Submit.

14.1.2 Silence Suppression (Compression)

Silence suppression (compression) is a method for conserving bandwidth on VoIP calls by
not sending packets when silence is detected. The device uses its VAD feature to detect
periods of silence in the voice channel during an established call. When silence is
detected, it stops sending packets in the channel.
The following procedure describes how to enable silence suppression using the Web
interface.
Version 6.8
155
14. Media
Mediant 500 E-SBC

Advertisement

Table of Contents
loading

Table of Contents