AudioCodes Mediant 500 E-SBC User Manual page 804

Parameter
[CASTablesNum]
CAS State Machines Parameters
Note: For configuring the CAS State Machine table using the Web interface, see ''Configuring CAS
State Machines'' on page 333. The CAS state machine can be configured only through the Web-
based management tool.
Web: Generate Digit On Time
[CASStateMachineGenerateDigitO
nTime]
Web: Generate Inter Digit Time
[CASStateMachineGenerateInterDi
gitTime]
Web: DTMF Max Detection Time
[CASStateMachineDTMFMaxOnDe
tectionTime]
Web: DTMF Min Detection Time
[CASStateMachineDTMFMinOnDet
ectionTime]
Web: MAX Incoming Address Digits
[CASStateMachineMaxNumOfInco
mingAddressDigits]
Web: MAX Incoming ANI Digits
[CASStateMachineMaxNumOfInco
mingANIDigits]
Web: Collect ANI
[CASStateMachineCollectANI]
Web: Digit Signaling System
[CASStateMachineDigitSignalingS
ystem]
User's Manual
Defines how many CAS protocol configurations files are
loaded.
The valid range is 1 to 8.
Note: For this parameter to take effect, a device reset is
required.
Generates digit on-time (in msec).
The value must be a positive value. The default is -1.
Generates digit off-time (in msec).
The value must be a positive value. The default is -1.
Detects digit maximum on time (according to DSP detection
information event) in msec units.
The value must be a positive value. The default is -1.
Detects digit minimum on time (according to DSP detection
information event) in msec units. The digit time length must be
longer than this value to receive a detection. Any number may
be used, but the value must be less than
CasStateMachineDTMFMaxOnDetectionTime.
The value must be a positive value. The default is -1.
Defines the limitation for the maximum address digits that
need to be collected. After reaching this number of digits, the
collection of address digits is stopped.
The value must be an integer. The default is -1.
Defines the limitation for the maximum ANI digits that need to
be collected. After reaching this number of digits, the collection
of ANI digits is stopped.
The value must be an integer. The default is -1.
In some cases, when the state machine handles the ANI
collection (not related to MFCR2), you can enable the state
machine to collect ANI or discard ANI.

[0] No = Don't collect ANI.

[1] Yes = Collect ANI.

[-1] Default = Default value.
Defines which Signaling System to use in both directions
(detection\generation).

[0] DTMF = DTMF signaling.

[1] MF = (Default) MF signaling.

[-1] Default = Default value.
804
Mediant 500 E-SBC
Description
Document #: LTRT-10427