AudioCodes Mediant 500 E-SBC User Manual page 195

User's Manual
3. Configure a SIP recording route according to the parameters described in the table
below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 15-6: SIP Recording Routing Parameter Descriptions
Parameter
Index
[SIPRecRouting_Index]
Recorded IP Group ID
CLI: recorded-ip-group-id
[SIPRecRouting_RecordedIPGroupID]
Recorded Source Prefix
CLI: recorded-src-prefix
[SIPRecRouting_RecordedSourcePrefix]
Recorded Destination Prefix
CLI: recorded-dst-prefix
[SIPRecRouting_RecordedDestinationPrefix]
Peer IP Group ID
CLI: peer-ip-group-id
[SIPRecRouting_PeerIPGroupID]
Caller
CLI: caller
[SIPRecRouting_Caller]
Recording Server (SRS) IP Group ID
CLI: srs-ip-group-id
[SIPRecRouting_SRSIPGroupID]
Version 6.8
Description
Defines an index number for the new table record.
Defines the IP Group participating in the call and
the recording is done on the leg interfacing with this
IP Group.
Note: For an SBC RTP-SRTP session, the
recorded IP Group must be set to the RTP leg if
recording is required to be RTP, or set to the SRTP
leg if recording is required to be SRTP.
Defines calls to record based on source number or
URI.
Defines calls to record based on destination
number or URI.
Defines the peer IP Group that is participating in
the call.
Defines which calls to record according to which
party is the caller.

[0] Both (default) = Caller can be peer or
recorded side

[1] Recorded Party

[2] Peer Party
Defines the IP Group of the recording server
(SRS).
Note: The SIP Interface used for communicating
with the SRS is according to the SRD assigned to
the SRS IP Group (in the IP Group table). If two
SIP Interfaces are associated with the SRD - one
for "SBC" and one for "GW &IP2IP" – the device
uses the "SBC" SIP Interface. If no SBC SIP
Interface type is configured, the device uses the
"GW & IP2IP" interface.
195
15. Services
Mediant 500 E-SBC