AudioCodes Mediant 500 E-SBC User Manual page 829

User's Manual
Parameter
Web: Send Digit Pattern on
Connect
EMS: Connect Code
CLI: digit-pttrn-on-conn
[TelConnectCode]
Web: Disconnect on Broken
Connection
EMS: Disconnect Calls on
Broken Connection
CLI: disc-broken-conn
[DisconnectOnBrokenConnecti
on]
Web: Broken Connection
Timeout
EMS: Broken Connection Event
Timeout
CLI: broken-connection-event-
timeout
[BrokenConnectionEventTimeo
ut]
Web: Disconnect Call on Silence
Detection
EMS: Disconnect On Detection
Of Silence
CLI: disc-on-silence-det
[EnableSilenceDisconnect]
Web: Silence Detection Period
[sec]
EMS: Silence Detection Time Out
[FarEndDisconnectSilencePeri
od]
Web: Silence Detection Method
[FarEndDisconnectSilenceMeth
od]
Version 6.8

This parameter is applicable to IP-to-Tel and Tel-to-IP calls.

This parameter is applicable only to ISDN and CAS protocols.
Defines a digit pattern to send to the Tel side after a SIP 200 OK
is received from the IP side. The digit pattern is a user-defined
DTMF sequence that is used to indicate an answer signal (e.g.,
for billing).
The valid range is 1 to 8 characters.
Note: This parameter is applicable only to CAS.
Global parameter that enables the device to release calls if RTP
packets are not received within a user-defined timeout
(configured by the BrokenConnectionEventTimeout parameter).
You can also configure this functionality per specific calls, using
IP Profiles (IpProfile_DisconnectOnBrokenConnection). For a
detailed description of this parameter and for configuring this
functionality in the IP Profile table, see ''Configuring IP Profiles''
on page 300.
Note: If this functionality is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated
with the IP Profile.
Defines the time period (in 100-msec units) after which a call is
disconnected if an RTP packet is not received.
The valid range is from 3 (i.e., 300 msec) to an unlimited value
(e.g., 20 hours). The default is 100 (i.e., 10000 msec or 10
seconds).
Notes:

This parameter is applicable only if the parameter
DisconnectOnBrokenConnection is set to 1.

Currently, this feature functions only if Silence Suppression is
disabled.
Determines whether calls are disconnected after detection of
silence.

[1] Yes = The device disconnects calls in which silence occurs
(in both call directions) for more than a user-defined time.

[0] No = (Default) Call is not disconnected when silence is
detected.
The silence duration can be configured by the
FarEndDisconnectSilencePeriod parameter (default 120).
Note: To activate this feature, set the parameters
EnableSilenceCompression and
FarEndDisconnectSilenceMethod to 1.
Defines the duration of the silence period (in seconds) after which
the call is disconnected.
The range is 10 to 28,800 (i.e., 8 hours). The default is 120
seconds.
Note: For this parameter to take effect, a device reset is required.
Determines the silence detection method.

[0] None = Silence detection option is disabled.

[1] Packets Count = According to packet count.
Note: For this parameter to take effect, a device reset is required.
829
53. Configuration Parameters Reference
Description
Mediant 500 E-SBC