AudioCodes Mediant 500 E-SBC User Manual page 261

User's Manual
The following procedure describes how to configure IP Groups in the Web interface. You
can also configure IP Groups using the table ini file parameter, IPGroup or CLI command,
configure voip > control-network ip-group.

To configure an IP Group:
1. Open the IP Group Table page (Configuration tab > VoIP menu > VoIP Network >
IP Group Table).
2. Click Add; the following dialog box appears:
3. Configure an IP Group according to to the parameters described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Parameter
Common Parameters
Index
[IPGroup_Index]
Type
CLI:type
[IPGroup_Type]
Version 6.8
Figure 17-5: IP Group Table - Add Dialog Box
Table 17-5: IP Group Table Parameter Descriptions
Defines an index for the new table record.
Defines the type of IP Group:

[0] Server = Used when the destination address, configured by the
Proxy Set, of the IP Group (e.g., ITSP, Proxy, IP-PBX, or
Application server) is known.

[1] User = Represents a group of users such as IP phones and
softphones where their location is dynamically obtained by the
device when REGISTER requests and responses traverse (or are
terminated) by the device. These users are considered remote (far-
Description
261
17. Control Network
Mediant 500 E-SBC