AudioCodes Mediant 500 E-SBC User Manual page 482

Parameter
Message Condition
[IP2IPRouting_MessageCondition]
CLI: message-condition
ReRoute IP Group ID
[IP2IPRouting_ReRouteIPGroupID]
CLI: re-route-ip-group-id
Call Trigger
[IP2IPRouting_Trigger]
CLI: trigger
Call Setup Rules Set Id
CLI: call-setup-rules-set-id
[IP2IPRouting_CallSetupRulesSetId]
Operation Routing Rule - Action
Destination Type
[IP2IPRouting_DestType]
CLI: dst-type
User's Manual
Assigns a SIP message Condition rule. To configure
Condition rules, see ''Configuring Message Condition Rules''
on page 476.
Defines the IP Group that initiated (sent) the SIP redirect
response (e.g., 3xx) or REFER message. This field is
typically used for re-routing requests (e.g., INVITEs) when
interworking is required for SIP 3xx redirect responses or
REFER messages. For more information, see ''Interworking
SIP 3xx Redirect Responses'' on page
''Interworking SIP REFER Messages'' on page 451,
respectively. This parameter functions together with the 'Call
Trigger' field (see below).
The default is -1 (i.e., not configured).
Defines the reason (i.e, trigger) for re-routing the SIP
request:

[0] Any = (Default) This routing rule is used for all
scenarios (re-routes and non-re-routes).

[1] 3xx = Re-routes the request if it was triggered as a
result of a SIP 3xx response.

[2] REFER = Re-routes the INVITE if it was triggered as
a result of a REFER request.

[3] 3xx or REFER = Applies to options [1] and [2].

[4] Initial only = This routing rule is used for regular
requests that the device forwards to the destination. This
rule is not used for re-routing of requests triggered by the
receipt of REFER or 3xx.
Assigns a Call Setup Rule Set ID to the routing rule. The
device performs the Call Setup rules of this Set ID if the
incoming call matches the characteristics of this routing rule.
The device routes the call to the destination according to the
routing rule's configured action, only after it has performed
the Call Setup rules.
For configuring Call Setup rules, see ''Configuring Call Setup
Rules'' on page 231.
Determines the destination type to which the outgoing SIP
dialog is sent.

[0] IP Group = (Default) The SIP dialog is sent to the IP
Group's Proxy Set (SERVER-type IP Group) or
registered contact from the database (if USER-type IP
Group).

[1] Dest Address = The SIP dialog is sent to the address
configured in the following fields: 'Destination SRD ID',
'Destination Address', 'Destination Port', and 'Destination
Transport Type'.

[2] Request URI = The SIP dialog is sent to the address
indicated in the incoming Request-URI. If the fields
'Destination Port' and 'Destination Transport Type' are
configured, the incoming Request-URI parameters are
overridden and these fields take precedence.

[3] ENUM = An ENUM query is sent to include the
destination address. If the fields 'Destination Port' and
482
Mediant 500 E-SBC
Description
449 and
Document #: LTRT-10427