Swinging The Boom; Raising And Lowering The Boom; Telescoping The Boom; Swinging The Jib - JLG 1350SJP Operation And Safety Manual

SECTION 4 - MACHINE OPERATION

Swinging the Boom

To swing boom, use Swing control to select Right or Left
direction.
WHEN SWINGING THE BOOM MAKE SURE THERE IS AMPLE ROOM FOR
THE BOOM TO CLEAR SURROUNDING WALLS, PARTITIONS AND EQUIP-
MENT.

Raising and Lowering the Boom

NOTE: The lift function is not operable above 15 degrees above
horizontal if the axles are not fully extended.
To raise or lower the Boom, use Boom Lift control to select
Up or Down movement.

Telescoping the Boom

NOTE: The telescope function is not operable beyond the trans-
port position if the axles are not fully extended.
To extend or retract the main boom, use the Telescope Control
Switch to select In or Out movement.
4-12

Swinging the Jib

NOTE: For 1000 lb. (454 kg for ANSI markets and 450 kg for CE
and Australia markets) mode operation, the jib must be
centered and the Jib Swing function is not operable. If the
jib is out of the centered position when in this mode, the
jib swing function will allow the operator to center the jib
again.
To swing the jib, use the Jib Swing control to select Right or
Left direction.

4.10 FUNCTION SPEED CONTROL

This control affects the speed of all boom functions and Plat-
form Rotate. When in the CCW maximum position, Drive is
placed in creep speed.
– JLG Lift – 3121141