Traveling Forward And Reverse; Steering; Extending The Axles - JLG 1350SJP Operation And Safety Manual

BEFORE DRIVING, LOCATE THE BLACK/WHITE ORIENTATION ARROWS
ON BOTH THE CHASSIS AND THE PLATFORM CONTROLS. MOVE THE
DRIVE CONTROLS IN A DIRECTION MATCHING THE DIRECTIONAL
ARROWS.

Traveling Forward and Reverse

1. At Platform Controls, pull out Emergency Stop switch,
start engine, and activate footswitch.
2. Position Drive controller to FORWARD or REVERSE as
desired.
This machine is equipped with a Drive Orientation Indicator.
The yellow light on the platform control console indicates
that the boom is swung beyond the rear drive tires and the
machine may Drive/Steer in the opposite direction from the
movement of the controls. If the indicator is illuminated,
operate the Drive function in the following manner:
3121141
SECTION 4 - MACHINE OPERATION
1. Match the black and white direction arrows on both plat-
form control panel and the chassis to determine the
direction the machine will travel.
2. Push and release the Drive Orientation Override switch.
Within 3 seconds, slowly move the Drive control toward
the arrow matching the intended direction of machine
travel. The indicator light will flash during the 3 second
interval until the drive function is selected.
4.6

STEERING

Position thumb switch on Drive/Steer controller to RIGHT for
steering right, or to LEFT for steering left.
4.7

EXTENDING THE AXLES

NOTE: The operator must be driving the machine (forward or
reverse) in order to extend the axles.
Position the Axle Extend switch to extend the axles or to
retract to retract the axles.
– JLG Lift – 4-9