Operator Maintenance - JLG 1350SJP Operation And Safety Manual

6.3

OPERATOR MAINTENANCE

NOTE: The following numbers correspond to those in Figure 6-
5., Lubrication and Maintenance Point Location.
Table 6-17. Lubrication Specifications
KEY
MPG Multipurpose Grease having a minimum dripping point of 350° F
(177° C). Excellent water resistance and adhesive qualities, and
being of extreme pressure type.
(Timken OK 40 pounds minimum.)
EPGL Extreme Pressure Gear Lube (oil) meeting API service classifica-
tion GL-5 or MIL-Spec MIL-L-2105
HO Hydraulic Oil. API service classification GL-3, e.g. Mobilfluid 424.
EO Engine (crankcase) Oil. Gas - API SF, SH, SG class, MIL-L-2104.
Diesel - API CC/CD class, MIL-L-2104B/MIL-L-2104C.
LUBRICATION INTERVALS ARE BASED ON MACHINE OPERATION
UNDER NORMAL CONDITIONS. FOR MACHINES USED IN MULTI-SHIFT
OPERATIONS AND/OR EXPOSED TO HOSTILE ENVIRONMENTS OR CON-
DITIONS, LUBRICATION FREQUENCIES MUST BE INCREASED ACCORD-
INGLY.
3121141
SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
SPECIFICATIONS
NOTE: It is recommended as a good practice to replace all filters
at the same time.
1. Swing Bearing - Remote Lube
Lube Point(s) - 2 Grease Fitting
Capacity - A/R
Lube - MPG
Interval - Every 3 months or 150 hours of operation
– JLG Lift – 6-15