JLG 1350SJP Operation And Safety Manual page 50

SECTION 3 - MACHINE CONTROLS AND INDICATORS
5. Tilt Alarm Warning Light and Alarm
Indicates that the chassis is on a slope. An alarm will
also sound when the chassis is on a slope and the
boom is above transport position. If lit when the boom is
raised or extended, retract and lower to below horizontal
then re-position machine so that it is level before contin-
uous operation. If the boom is above transport position
or telescoped, out and the machine is on a slope, the tilt
alarm warning light will illuminate and an alarm will
sound and CREEP is automatically activated.
IF ILLUMINATED WHEN BOOM IS RAISED OR EXTENDED, RETRACT AND
LOWER TO BELOW HORIZONTAL THEN REPOSITION MACHINE SO THAT
IT IS LEVEL BEFORE EXTENDING BOOM OR RAISING BOOM more than
15 degrees ABOVE HORIZONTAL.
6. Glow Plug Indicator
Indicates the glow plugs are operating. After turning on
ignition, wait until light goes out before cranking engine.
3-18
7. Footswitch/Enable Indicator
To operate any function, the footswitch must be
depressed and the function selected within seven sec-
onds. The enable indicator shows that the controls are
enabled. If a function is not selected within seven sec-
onds, or if a seven second lapse between ending one
function and beginning the next function, the enable
light will go out and the footswitch must be released and
depressed again to enable the controls.
Releasing the footswitch removes power from all con-
trols and applies the drive brakes.
TO AVOID SERIOUS INJURY, DO NOT REMOVE, MODIFY OR DISABLE
THE FOOTSWITCH BY BLOCKING OR ANY OTHER MEANS.
FOOTSWITCH MUST BE ADJUSTED IF FUNCTIONS ACTIVATE WHEN
SWITCH ONLY OPERATES WITHIN LAST 1/4" OF TRAVEL, TOP OR BOT-
TOM.
– JLG Lift – 3121141