JLG 1350SJP Operation And Safety Manual page 44

SECTION 3 - MACHINE CONTROLS AND INDICATORS
14. Jib Stow Override
This switch allows the operator to rotate the jib to the
right past the electronic stop to stow the jib under the
boom for transport.
15. Function Speed Control
Controls the speed of Boom and Swing Functions.
Rotate CCW for slower speed and CW for faster speed.
To adjust to creep, turn knob fully CCW until it clicks.
NOTE: To operate the Main Lift/Swing Joystick, pull up on the
locking ring below the handle.
NOTE: The MAIN LIFT/SWING control lever is spring-loaded and
will automatically return to neutral (OFF) position when
released.
16. Main Lift/Swing Controller
An infinitely proportional dual axis joystick is provided
for main lift and swing. Push forward to lift up, pull back-
ward to lift down. Move right to swing right, move left to
swing left.
3-12
NOTE: When boom is positioned above transport position or tele-
scoped out and any of the following switches, DRIVE
SPEED/TORQUE SELECT or FUNCTION SPEED, are posi-
tioned to HIGH, high function speeds are automatically
cut out and the machine continues to operate at a lower
speed.
DO NOT OPERATE MACHINE IF DRIVE SPEED /TORQUE SELECT OR
FUNCTION SPEED SWITCHES OPERATE WHEN BOOM IS MORE THAN
15° ABOVE HORIZONTAL.
17. Drive Speed/Torque Select
The forward position gives maximum drive speed by
shifting the drive motors to minimum displacement and
giving high engine when drive controller is moved. The
back position gives maximum torque for rough terrain
and climbing grades by shifting the wheel motors to
maximum displacement and giving high engine speed
when drive controller is moved. The center position
allows the machine to be driven as quietly as possible
by leaving the engine at mid speed and the drive motors
in maximum displacement.
– JLG Lift – 3121141