Replacing A Hard Drive - Sun Microsystems Ultra 2 series Service Manual

9.1.2

Replacing a Hard Drive

Note –
system. Sun Ultra 2 series systems do not support hard drives taller than 1 inch
(2.54 cm).
Caution –
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
1. Replace a hard drive as follows (
a. Remove the hard drive from the antistatic bag.
Note –
settings, or other installation tasks.
Caution –
target address 0, front drive slot is target address 1). Make note of the drive slot in
which each hard drive is installed. Installing a hard drive into the incorrect drive slot
could cause a file system or system boot problem.
b. Open the drive handle and proceed as follows:
Slide the drive into the chassis drive slot.
Firmly press the hard drive to connect it to the system.
c. Close the hard drive handle.
Note –
2. Replace the EMI door.
3. Detach the wrist strap.
4. Replace the system unit cover.
See Section 7.3 "Replacing the System Unit Cover" on page 7-4.
5. Power on the system unit.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
See Section 6.1 "Powering On the System Unit" on page 6-1.
Use only hard drives that are specifically designed for a Sun Ultra 2 series
Use proper ESD grounding techniques when handling components. Wear
Read the hard drive product guide for information about jumpers, switch
Each hard drive slot has a unique SCSI target address (rear drive slot is
The drive handle will not latch if the hard drive is not properly installed.
):
FIGURE 9-1