Modem Switch Settings (AT Commands)
Enable transmit flow control (AT&H1) [suggested setting] (required for sending
binary/8-bit data)
Set link rate to fixed (will not track modem data rate, AT&Bn;
n equals menu choice in modem manual.)
Set display result codes (ATQ0)
Set verbal result codes (ATV1)
Set result code subset (ATXn; n equals option choice)
Save settings in NVRAM (AT&W)
Note –
The above settings are guidelines to help you get started quickly. Changes to
these guidelines should be expected depending on the site requirements and the
modem being used. For additional information about modem switch settings, see the
manual that came with your modem.
C.1.13
Printer Connectivity
Parallel printer port connectivity is provided with a DB25 connector. This interface
supports up to two Mbytes-per-second data throughput and is
Centronics-compatible. All SPARC printers are supported (see
C.1.14
Audio
Audio includes interface, built-in speaker, and microphone (see
C.1.14.1
Interface
The system unit or server includes the Codec for audio functionality. Four external
connectors are supplied: line input, line output, a headphone, and stereo
microphone. All connectors are 0.125-inch (3.5-mm) mini-stereo connectors. Line-in
and line-out connectors support 16-bit CD quality stereo. The following table lists
each audio port function.
specifications.
C-20
Sun Ultra 2 Series Service Manual • July 1996
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
identifies the audio input and output
TABLE C-3
).
FIGURE C-1
).
FIGURE C-1