Figure - Sun Microsystems Ultra 2 series Service Manual

2. Push the power supply toward the chassis rear, engaging the mounting hooks.
Note –
Ensure that the hooks located on the chassis base engage with the cutouts
located on the bottom of the power supply.
3. Using a number 2 Phillips screwdriver, tighten the captive screws securing the
power supply to the back panel.
4. Connect the following power supply connectors to the motherboard (
J4 to J3204
J3 to J3203
J2 to J3205
J1 to J3206
5. Connect the J6 power supply connector to the diskette drive.
6. Connect the J5 power supply connector to the CD-ROM drive (or 4-mm/8-mm tape
drive).
7. Connect the AC power cord.
8. Detach the wrist strap.
9. Replace the system unit cover.
See Section 7.3 "Replacing the System Unit Cover" on page 7-4.
10. Power on the system unit.
See Section 6.1 "Powering On the System Unit" on page 6-1.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
:

FIGURE 8-2