Replacing A Diskette Drive - Sun Microsystems Ultra 2 series Service Manual

9.4.2

Replacing a Diskette Drive

Caution –
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
1. Replace the diskette drive as follows (
Note –
settings, or other installation tasks.
a. Using a number 2 Phillips screwdriver, replace the four screws securing the
diskette drive to the chassis bracket.
b. Remove the diskette data cable from the kit. Replace the diskette data cable
assembly.
See Section 8.2.4 "Replacing the Diskette Drive Cable Assembly" on page 8-9.
2. Replace the chassis bracket.
See Section 9.2.2 "Replacing the Chassis Bracket" on page 9-5.
3. Route the diskette data cable under the clip on the side of the chassis bracket.
4. If necessary, replace the CD filler panel.
5. Detach the wrist strap.
6. Replace the system unit cover.
See Section 7.3 "Replacing the System Unit Cover" on page 7-4.
7. Power on the system unit.
See Section 6.1 "Powering On the System Unit" on page 6-1.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Use proper ESD grounding techniques when handling components. Wear
Read the disk drive product guide for information about jumpers, switch
):
FIGURE 9-4