Options; A.6 Options - Emerson Rosemount 2051 Reference Manual

Reference Manual
00809-0100-4107, Rev BA
A.6

Options

Standard configuration
Unless otherwise specified, transmitter is shipped as follows:
Engineering units
Differential/Gage:
Absolute/Rosemount
2051TA:
4 mA :
20 mA:
Output:
Flange type:
Flange material:
O-ring material:
Drain/vent:
LCD Display:
Alarm:
Software tag:
Custom configuration
If Option Code C1 is ordered, the customer may specify the following data in addition to the
standard configuration parameters.





Refer to the "Rosemount Enhanced Rosemount 2051 Configuration Data Sheet" document
number 00806-0100-4107.
Tagging (3 options available)



Appendix A: Specifications and Reference Data
inH O (Range 0, 1, 2, and 3)
2
psi (Range 4 and 5)
psi (all ranges)
0 (engineering units above)
Upper range limit
Linear
Specified model code option
Specified model code option
Specified model code option
Specified model code option
Installed or none
High
(Blank)
Output Information
Transmitter Information
LCD Display Configuration
Hardware Selectable Information
Signal Selection
Standard SST hardware tag is wired to the transmitter. Tag character height is 0.125 in.
(3,18 mm), 56 characters maximum.
Tag may be permanently stamped on transmitter nameplate upon request, 56
characters maximum.
Tag may be stored in transmitter memory. Character limit is dependent on protocol.
–- HART Revision 5: 8 characters
–- HART Revision 7: 32 characters
Appendix A: Specifications and Reference Data
April 2013
159