Reset And Supply Management; Power Supply Schemes; Power Supply Supervisor - STMicroelectronics STM32L151CB Manual

Functional overview
Nested vectored interrupt controller (NVIC)
The ultralow power STM32L15xx6/8/B embeds a nested vectored interrupt controller able to
handle up to 45 maskable interrupt channels (not including the 16 interrupt lines of Cortex
M3) and 16 priority levels.
•
Closely coupled NVIC gives low-latency interrupt processing
• Interrupt entry vector table address passed directly to the core
•
Closely coupled NVIC core interface
• Allows early processing of interrupts
•
Processing of late arriving, higher-priority interrupts
• Support for tail-chaining
•
Processor state automatically saved
• Interrupt entry restored on interrupt exit with no instruction overhead
This hardware block provides flexible interrupt management features with minimal interrupt
latency.
3.3

Reset and supply management

3.3.1

Power supply schemes

•
V
DD
Provided externally through V
•
V
SSA
and PLL (minimum voltage to be applied to V
V
DDA
3.3.2

Power supply supervisor

The device has an integrated ZEROPOWER power-on reset (POR)/power-down reset
(PDR) that can be coupled with a brownout reset (BOR) circuitry.
The device exists in two versions:
•
The version with BOR activated at power-on operates between 1.8 V and 3.6 V.
•
The other version without BOR operates between 1.65 V and 3.6 V.
After the V
not at power-on), the option byte loading process starts, either to confirm or modify default
thresholds, or to disable the BOR permanently: in this case, the V
1.65 V (whatever the version, BOR active or not, at power-on).
When BOR is active at power-on, it ensures proper operation starting from 1.8 V whatever
the power ramp-up phase before it reaches 1.8 V. When BOR is not active at power-up, the
power ramp-up should guarantee that 1.65 V is reached on V
the POR area.
18/129
= 1.65 to 3.6 V: external power supply for I/Os and the internal regulator.
, V = 1.65 to 3.6 V: external analog power supplies for ADC, reset blocks, RCs
DDA
and V must be connected to V
SSA
threshold is reached (1.65 V or 1.8 V depending on the BOR which is active or
DD
DocID17659 Rev 10
STM32L151x6/8/B, STM32L152x6/8/B
pins.
DD
is 1.8 V when the ADC is used).
DDA
and V
DD SS
, respectively.
min value becomes
DD
at least 1 ms after it exits
DD
®
-