STMicroelectronics STM32L151CB Manual page 125

STM32L151x6/8/B, STM32L152x6/8/B
Date
17-June-2011
25-Jan-2012
Table 71. Document revision history (continued)
Revision
Modified 1st page (low power features)
Added STM32L15xC6 and STM32L15xR6 devices (32 Kbytes of
Flash memory).
Modified Section 3.6: GPIOs (general-purpose inputs/outputs) on
5 page 22
Modified Section 6.3: Operating conditions on page 51
Modified Table 55: ADC accuracy on page
characteristics on page 98
characteristics on page 101
Features: updated internal multispeed low power RC.
Table 2: Ultralow power STM32L15xx6/8/B device features and
peripheral counts: LCD 4x44 and 8x40 available for both 64- and
128-Kbyte devices; two comparators available for all devices.
Table 3: Functionalities depending on the operating power supply
range: added footnote 1.
Figure 8: STM32L15xCx UFQFPN48
UFQFPN48 as name of package.
Table 8: STM32L15xx6/8/B pin
PC14/PC15.
Table 9: Alternate function
PH2 port, AFIO15 column.
Table 19: Current consumption in Sleep
conditions and f
Table 20: Current consumption in Low power run
some temperature conditions; added footnote
Table 21: Current consumption in Low power sleep
some temperature conditions and one of the MSI clock conditions.
Table 22: Typical and maximum current consumptions in Stop
mode: updated I
6
Table 23: Typical and maximum current consumptions in Standby
mode: updated I
Table 25: Low-power mode wakeup
for t
WUSLEEP_LP
Stop mode, regulator in Run mode".
Table 24: Peripheral current
GPIOH.
Table 33: PLL
Table 35: Flash memory and data EEPROM
updated all information for I
Figure 19: I/O AC characteristics
edge "t
r(IO)out
2
Table 47: I C
Table 54: ADC
channels, 6-bit sampling rate.
Table 55: ADC
condition.
Table 59: Temperature sensor
and max values of the T
DocID17659 Rev 10
Changes
and Table 60: Comparator 1
definitions: replaced PH0/PH1 by
input/output: removed EVENT OUT from
.
HCLK
(WU from Stop) parameter.
DD
(WU from Standby) parameter.
DD
timings: updated f
; updated typical value of parameter "Wakeup from
consumption: replaced GPIOF by
characteristics: updated "PLL output clock"
.
DD
definition: replaced the falling
" by "t ".
f(IO)out
characteristics: amended footnote
characteristics: updated f
accuracy: Updated the first, third and fourth f
characteristics: updated typ, min,
parameter.
S_temp
Revision history
94, Table 57: DAC
pinout: replaced VFQPN48 by
mode: updated MSI
mode: updated
2.
mode: updated
value
HCLK
characteristics:
2.
max value for direct
S
ADC
125/129
test
128