FSPF Interface Configuration
Command or Action
Step 3
fspf cost value vsan vsan-id
Example:
switch(config-if)# fspf cost 500 vsan 38
Hello Time Intervals
You can set the FSPF Hello time interval to specify the interval between the periodic hello messages that are
sent to verify the health of the link. The integer value can range from 1 to 65,535 seconds.
Note
This value must be the same in the ports at both ends of the ISL.
Configuring Hello Time Intervals
You can configure the FSPF Hello time interval.
SUMMARY STEPS
1. configure terminal
2. switch(config)# interface fc slot/port
3. fspf hello-interval value vsan vsan-id
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
switch(config)# interface fc slot/port
Step 3
fspf hello-interval value vsan vsan-id
Example:
switch(config-if)# fspf hello-interval 25 vsan
10
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
186
Configuring Fibre Channel Routing Services and Protocols
Purpose
Configures the cost for the selected interface in the specified
VSAN.
Purpose
Enters global configuration mode.
Configures the specified interface, or if already configured,
enters configuration mode for the specified interface.
Specifies the hello message interval to verify the health of
the link in the VSAN. The default is 20 seconds.
OL-27583-01