Configuring The Port-Address Format; Displaying Rscn Information - Cisco Nexus 5000 Series Configuration Manual

RSCN

Configuring the Port-Address Format

The zone server on Cisco SAN switches allows you to switch between the fabric-address format and port-address
format. You can configure this feature on a per VSAN basis. This configuration remains unchanged even
after an In-Service Software Upgrade (ISSU) or a switchover. By default, the Registered State Change
Notification (RSCN) format is fabric address
You can configure the port-address format.
SUMMARY STEPS
1. configure terminal
2. zone rscn address-format port vsan vsan-id
3. no zone rscn address-format port vsan vsan-id
4. show zone status vsan vsan-id
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
zone rscn address-format port vsan vsan-id
Example:
switch(config)# zone rscn address-format port vsan 10
Step 3 no zone rscn address-format port vsan vsan-id
Example:
switch(config)# no zone rscn address-format port vsan
10
Step 4 show zone status vsan vsan-id
Example:
switch(config)# show zone status vsan 10

Displaying RSCN Information

The following example shows how to display registered device information:
switch# show rscn scr-table vsan 1
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
206
Managing FLOGI, Name Server, FDMI, and RSCN Databases
Purpose
Enters global configuration mode.
Switches to the port-address format.
Reverts to the default format that is
fabric-address format.
Displays the active the RSCN address format.
OL-27583-01