About Hello Time Intervals; Configuring Hello Time Intervals - Cisco Nexus 5000 Series Configuration Manual

Configuring Fibre Channel Routing Services and Protocols
DETAILED STEPS
Command or Action
Step 1
switch# configuration terminal
Step 2
switch(config)# interface fc slot/port
Step 3 switch(config-if)# fspf cost value vsan vsan-id

About Hello Time Intervals

You can set the FSPF Hello time interval to specify the interval between the periodic hello messages sent to
verify the health of the link. The integer value can range from 1 to 65,535 seconds.
This value must be the same in the ports at both ends of the ISL.
Note

Configuring Hello Time Intervals

To configure the FSPF Hello time interval, perform this task:
SUMMARY STEPS
1. switch# configuration terminal
2. switch(config)# interface fc slot/port
3. switch(config-if)# fspf hello-interval value vsan vsan-id
DETAILED STEPS
Command or Action
Step 1 switch# configuration terminal
Step 2 switch(config)# interface fc slot/port
Step 3 switch(config-if)# fspf hello-interval value vsan
vsan-id
OL-xxxxx-xx
Purpose
Enters configuration mode.
Configures the specified interface, or if already configured,
enters configuration mode for the specified interface.
Configures the cost for the selected interface in the specified
VSAN.
Purpose
Enters configuration mode.
Configures the specified interface, or if already configured, enters
configuration mode for the specified interface.
Specifies the hello message interval to verify the health of the
link in VSAN 175. The default is 20 seconds.
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide
FSPF Interface Configuration
149