Configuring An Allowed-Active List Of Vsans - Cisco Nexus 5000 Series Configuration Manual

Configuring VSAN Trunking
VSAN 2 can only be routed from switch 1 through switch 3 to switch 2.
Figure 19: Operational and Allowed VSAN Configuration

Configuring an Allowed-Active List of VSANs

You can configure an allowed-active list of VSANs for an interface.
SUMMARY STEPS
1. configure terminal
2. switchport trunk allowed vsan vsan-id - vsan-id
3. switchport trunk allowed vsan add vsan-id
4. no switchport trunk allowed vsan vsan-id - vsan-id
5. no switchport trunk allowed vsan add vsan-id
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
OL-27583-01
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
Configuring VSAN Trunking
Purpose
Enters global configuration mode.
91