Configuring Device Types For Zone Members - Cisco Nexus 5000 Series Configuration Manual

Configuring and Managing Zones
SUMMARY STEPS
1. switch# configure terminal
2. switch(config)# zone smart-zone enable vsan1
DETAILED STEPS
Command or Action
Step 1
switch# configure terminal
Step 2
switch(config)# zone smart-zone enable vsan1

Configuring Device Types for Zone Members

To configure the device types for zone members, perform these tasks:
SUMMARY STEPS
1. switch# configure terminal
2. switch (config)# zoneset name zoneset1
3. switch(config-zoneset-zone)# member device-alias mds9000 both
4. switch(config-zoneset-zone)# member pwnn 10:00:00:23:45:67:89:ab
5. switch(config-zoneste-zone)# member fcid 2020:dbc0:80::4076
DETAILED STEPS
Command or Action
Step 1 switch# configure terminal
Step 2 switch (config)# zoneset name zoneset1
Step 3 switch(config-zoneset-zone)# member
device-alias mds9000 both
Step 4 switch(config-zoneset-zone)# member pwnn
10:00:00:23:45:67:89:ab
Step 5 switch(config-zoneste-zone)# member fcid
2020:dbc0:80::4076
OL-27583-01
Purpose
Enters global configuration mode.
Enters global configuration mode.
Configures the device type for the device-alias member as both. For
every supported member-type, init, target, and both are supported.
Configures the device type for the pwwn member as target. For every
supported member-type, init, target, and both are supported.
Configures the device type for the FCID member. There is no specific
device type that is configured. For every supported member-type, init,
target, and both are supported.
Note When there is no specific device type configured for a zone
member, at the backend, zone entries that are generated are
created as device type both.
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
Configuring Device Types for Zone Members
Purpose
Enters global configuration mode.
Smart Zoning is enabled for the selected zone.
153