Configuring The Default Zone Access Permission; Fc Alias Creation - Cisco Nexus 5000 Series Configuration Manual

Configuring and Managing Zones

Configuring the Default Zone Access Permission

To permit or deny traffic to members in the default zone, perform this task:
SUMMARY STEPS
1. configure terminal
2. zone default-zone permit vsan vsan-id
3. no zone default-zone permit vsan vsan-id
DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
zone default-zone permit vsan vsan-id
Example:
switch(config)# zone default-zone permit vsan 13
Step 3 no zone default-zone permit vsan vsan-id
Example:
switch(config)# no zone default-zone permit vsan 40

FC Alias Creation

You can assign an alias name and configure an alias member using the following values:
• pWWN—The WWN of the N port is in hex format (for example, 10:00:00:23:45:67:89:ab).
• fWWN—The WWN of the fabric port name is in hex format (for example, 10:00:00:23:45:67:89:ab).
• FC ID—The N port ID is in 0xhhhhhh format (for example, 0xce00d1).
• Domain ID—The domain ID is an integer from 1 to 239. A mandatory port number of a non-Cisco
• Interface—Interface-based zoning is similar to port-based zoning because the switch interface is used
OL-27583-01
switch is required to complete this membership configuration.
to configure the zone. You can specify a switch interface as a zone member for both local and remote
switches. To specify a remote switch, enter the remote switch WWN (sWWN) or the domain ID in the
particular VSAN.
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
Purpose
Enters global configuration mode.
Permits traffic flow to default zone members.
Denies (default) traffic flow to default zone
members.
Zone Sets
141