Displaying Latency Information; Flow Statistics Configuration; Flow Statistics; Counting Aggregated Flow Statistics - Cisco Nexus 5000 Series Configuration Manual

Flow Statistics Configuration

Command or Action
Step 4
no fcdroplatency network value
Example:
switch(config)# no fcdroplatency network 1000

Displaying Latency Information

You can view the configured latency parameters by using the show fcdroplatency command:
switch# show fcdroplatency
switch latency value:500 milliseconds
global network latency value:2000 milliseconds
VSAN specific network latency settings
vsan 1 network latency:5000 milliseconds
vsan 2 network latency:2000 milliseconds
vsan 103 network latency:2000 milliseconds
vsan 460 network latency:500 milliseconds
Flow Statistics Configuration
Flow statistics count the ingress traffic in the aggregated statistics table. You can collect two kinds of statistics:
• Aggregated flow statistics to count the traffic for a VSAN.
• Flow statistics to count the traffic for a source and destination ID pair in a VSAN.

Flow Statistics

If you enable flow counters, you can enable a maximum of 1000 entries for aggregate flow and flow statistics.
Be sure to assign an unused flow index for each new flow. The number space for flow index is shared between
the aggregate flow statistics and the flow statistics.

Counting Aggregated Flow Statistics

You can count the aggregated flow statistics for a VSAN.
SUMMARY STEPS
1. configure terminal
2. fcflow stats aggregated index value vsan vsan-id
3. no fcflow stats aggregated index value vsan vsan-id
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
196
Configuring Fibre Channel Routing Services and Protocols
Purpose
Removes the current fcdroplatency network configuration and
reverts the switch to the factory defaults.
OL-27583-01