Tftp - HP A7500 Series Command Reference Manual

Default level
3: Manage level
Parameters
ipv6: References an IPv6 ACL. If it is not specified, an IPv4 ACL is referenced.
acl-number: Number of a basic ACL, in the range of 2000 to 2999.
Description
Use the tftp-server acl command to control the device's access to a specific TFTP server using an ACL.
Use the undo tftp-server acl command to restore the default.
By default, no ACL is used to control the device's access to TFTP servers.
You can use an ACL to deny or permit the device's access to a specific TFTP server.
For more information about ACL, see ACL and QoS Configuration Guide.
Examples
# Allow the device to access the TFTP server with the IP address of 1.1.1.1 only (in the IPv4 networking
environment).
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 1.1.1.1 0
[Sysname-acl-basic-2000] quit
[Sysname] tftp-server acl 2000
# Allow the device to access the TFTP server with the IP address of 2001::1 only (in the IPv6 networking
environment).
<Sysname> system-view
[Sysname] acl ipv6 number 2001
[Sysname-acl6-basic-2001] rule permit source 2001::1/128
[Sysname-acl6-basic-2001] quit
[Sysname] tftp-server ipv6 acl 2001

tftp

Syntax
tftp server-address { get | put | sget } source-filename [ destination-filename ] [ vpn-instance
vpn-instance-name ] [ source { interface interface-type interface-number | ip source-ip-address } ]
View
User view
Default level
3: Manage level
Parameters
server-address: IP address or host name of a TFTP server.
get: Downloads a file in normal mode.
put: Uploads a file.
sget: Downloads a file in secure mode.
73