Patch Active - HP A7500 Series Command Reference Manual

Field
Version
Temporary
Common
Current
Running
Active
Start-Address

patch active

Syntax
In standalone mode:
patch active [ patch-number ] slot slot-number
In IRF mode:
patch active [ patch-number ] chassis chassis-number slot slot-number
View
System view
Default level
3: Manage level
Parameters
patch-number: Sequence number of a patch, with values depending on the patch file used.
slot slot-number: Specifies a card by its slot number. (in standalone mode)
chassis chassis-number slot slot-number: Specifies a card on an IRF member switch. The chassis-number
argument refers to the ID of the IRF member switch, and the slot-number argument refers to the number of
the slot where the card resides. (in IRF mode)
Description
Use the patch active command to activate patches. The system will temporarily run the loaded patches.
If you execute the command with specifying the sequence number of a patch, all the DEACTIVE
•
patches (including the specified patch) before the specified patch will be activated.
If you execute the command without specifying the sequence number of a patch, all the DEACTIVE
•
patches will be activated.
NOTE:
The command is applicable to only patches in the DEACTIVE state.
•
After a system reboot, the original ACTIVE patches change to DEACTIVE and become invalid. To make
•
them effective, activate them again.
Description
Patch version.
Number of temporary patches
Number of common patches
Total number of patches
Number of patches in the RUNNING state
Number of patches in the ACTIVE state
Starting address of the memory patch area in the memory
127