Backup Startup-Configuration; Configuration Replace File - HP A7500 Series Command Reference Manual

the newly configured upper limit is 4, when there is a new configuration file to be saved, the system
deletes 4 oldest files, where 4 = 7-4+1.
Before executing this command, configure the path and filename prefix for saving configuration files by
using the archive configuration location command; otherwise, the execution of this command fails.
If you execute the undo archive configuration location command, the maximum number of configuration
files that can be saved also restores to the default.
Examples
# Set the maximum number of configuration files that can be saved to 10.
<Sysname> system-view
[Sysname] archive configuration max 10

backup startup-configuration

Syntax
backup startup-configuration to dest-addr [ dest-filename ]
View
User view
Default level
2: System level
Parameters
dest-addr: IP address or name of a TFTP server. The address cannot be an IPv6 address.
dest-filename: Target filename used to save the startup configuration file on the server.
Description
Use the backup startup-configuration command to back up the startup configuration file to a specified
TFTP server. If you do not specify this filename, the original filename is used.
The device uses TFTP to back up configuration files.
Examples
# Back up the startup configuration file of the device to the TFTP server with IP address 2.2.2.2, using
filename 192-168-1-26.cfg.
<Sysname> backup startup-configuration to 2.2.2.2 192-168-1-26.cfg
Backup next startup-configuration file to 2.2.2.2, please wait...finished!
<Sysname>
After the above operation, the device backs up file test.cfg to TFTP server 2.2.2.2, where the file is saved
as 192-168-1-26.cfg.

configuration replace file

Syntax
configuration replace file filename
View
System view
102