Patch Load - HP A7500 Series Command Reference Manual

Entering n or N: All the specified patches are installed and turn to the ACTIVE state from IDLE. This
•
equals execution of the commands patch location, patch load and patch active. The patches turn to
the DEACTIVE state after system reboot.
Before executing the command, save patch files to the specified directory. Note that the following rules
apply:
In standalone mode, if you install patches from patch packages, save the patch packages to any
•
directory on the active MPU.
• In standalone mode, if you install patches from patch files, save the patch files for the active MPU
or LPUs to the root directory of the Flash on the active MPU; and save the patch files for the standby
MPU to the root directory of the flash on the standby MPU.
Examples
# Install the patches located on the Flash. (The output of this command varies with devices.)
<Sysname> system-view
[Sysname] patch install flash:
Patches will be installed. Continue? [Y/N]:y
Do you want to run patches after reboot? [Y/N]:y
Installing patches...
# Install the specified patch package. (The output of this command varies with devices.)
<Sysname> system-view
[Sysname] patch install file:/patch_packeg.bin
Patches will be installed. Continue? [Y/N]:y
Do you want to run patches after reboot? [Y/N]:y
Installing patches...

patch load

Syntax
In standalone mode:
patch load slot slot-number [ file filename ]
In IRF mode:
patch load chassis chassis-number slot slot-number [ file filename ]
View
System view
Default level
3: Manage level
Parameters
slot slot-number: Specifies a card by its slot number. (In standalone mode)
chassis chassis-number slot slot-number: Specifies a card on an IRF member switch. The chassis-number
argument refers to the ID of the IRF member switch, and the slot-number argument refers to the number of
the slot where the card resides. (In IRF mode)
file filename: Filename of a patch package.
131