Water Resistant Analog Clock Installation
Supplied Hardware Kit Contents
The following parts are supplied with the clock.
Part Description
O-ring
Screws
Anchors
Washers
Tube of lubricant
Complete the steps below to install a water resistant analog clock.
1. Remove the clock assembly from the mounting back.
CAUTION:
A pre-assembled O-ring has been inserted by the factory between the lens and the case. Removal of this
lens and/or O-ring voids the manufacturer warranty.
2. From the back of the clock, remove the parts from the supplied hardware kit.
3. From the back of the clock, remove and discard the two spacers.
Primex Wireless
Quantity
1
4
4
4
1
XR Series Analog Clock Installation Guide
32