Dual-Sided Metal Series Analog Clock Installation - Primex XR Series Installation Manual

Dual-Sided Metal Series Analog Clock Installation

Supplied hardware
(1) Mounting plate
(4) Long screws
(4) Wall anchors
Install and mount clock
NOTE: Before mounting, apply power to the clock.
Models" located on page 17.
1. Secure the mounting plate to the wall or ceiling with the four long screws, paying attention to the "up" arrow, at
the location you will be hanging the clock.
2. Remove one clock from the bracket by removing two of the four factory installed screws. With the dual clock flat
on a soft surface to protect the lens and bezel, remove the two top screws and lift the top clock off of the dual
mounting bracket.
NOTE: It may require some force to remove the top clock because, in addition to the screws, the clocks are also held
in place by magnets.
3. Set each clock using method detailed on the setup instruction sticker on the back of each clock.
4. Once the clocks are set (with batteries inserted), orient the clock face so that the 12 is in the correct position for
your mounting option.
NOTE: Clocks are shipped in correct position for wall mounting. If ceiling mount is required, both clocks must be
removed and rotated within the bracket.
5. Align one of the posts on the back of the clock with the appropriate post in the bracket, next to a clip. Make sure
that the raised portion of the clip next to the post is inside the bracket.
Primex Wireless
For additional information, see "Apply Power - Battery Operated
XR Series Analog Clock Installation Guide
28