Primex XR Series Installation Manual page 29

6. Lower the clock down on the bracket, keeping all clips inside ring. Press down to seat the clock in bracket. Secure
with the two screws removed previously, in same holes in bracket (over screws holding other clock in place.)
7. If necessary, use the four additional screws included in the package to cosmetically plug holes in bracket.
8. Check to make sure that the 12 o'clock position is oriented to read correctly from both sides of the clock.
9. Taking the fully assembled dual clock, line up the base (stem) of the clock with the plate that is mounted on the
wall. Slip the keyhole slots on the back of the base over the posts on the plate and push the clock down to secure.
Primex Wireless
XR Series Analog Clock Installation Guide
29