Remote Antenna Analog Clock Installation Instructions - Primex XR Series Installation Manual

Remote Antenna Analog Clock Installation Instructions

Supplied Hardware Kit Contents
The following parts are supplied with the clock.
Ref
1
2
3
4
5
6
7
8
Mounting Guidelines
The cable can exit the clock through the top, through the bottom, or directly into the wall behind the clock.
l
The length of the 15 foot cable can be increased by adding cables and adapters up to a maximum
l
recommended length of 45 feet.
The cable can be placed in any position, but the antenna is required to be mounted vertically and away from
l
metal objects.
The clock setup procedure may be done with or without the cable and antenna connected; however, unless
l
you are very close to the transmitter the clock will not set to the time without the antenna connected. If the
clock is set up without the antenna, after connecting the cable with the antenna, it is recommended that you
press the button located on the back of the clock twice to verify signal reception; it may take up to 1-1/2
minutes to receive a signal.
Installation Steps
Complete the steps below to install a remote antenna analog clock. Refer to Figure 5 for the illustration of the clock
components, as referenced in the steps below.
Primex Wireless
Part Description
Connector with solder terminals
Cable 15 foot
Remote mounting bracket
Screws (2) for mounting bracket
Connector
Right angle connector
Antenna
Flat washer
Optional Accessory: 6.5" cable extension with BNC adapter
XR Series Analog Clock Installation Guide
Quantity
1
1
1
2
1
1
1
1
30